Features:
- Sensor closed look temperature control , quick temp rise , easy set temp , stable temperature.
- Anti –static design , avoid hurting PCB by static and leakage.
- Adopts imported heater , speedy temperature rise , long service life , good soldering safety performance constant and adjustable temperature
- Adopts high quality air pump. low vibration , non –noise design , keep the working environment clean and quiet.
- LED display indicator temp , accurate control , easier operation
- Intelligent cooling system after work completed shut off, delay air supply , automatic cut off the power when air temp is lower than 100’c . better protect the heating material , handle air head extend the service life.
- Apply to most surface mount parts disordering. Can safely disordering QFP,PLCC, SOP,BGA etc temperature sensitive element.
Specification
| Model No | JAS-852D |
| Input voltage | AC220V 50Hz |
| Watt Consumption | 600W |
| Pump type | Diaphragm Pump |
| Airflow rate | 0.5-23L/min |
| Heating Unit | Ceramic Heating uni A1321 Heating Unit |
| Iron temperature | 200-500°C |
| Air Gun Temperature | 100-480°C |
| Bits Earth Resistance | <2Ω |
| Bits Drain Voltage | <2mv |
FAQs
The station supports AC 220 V 50 Hz input, 600 W power consumption, iron temperature range 200–500 °C, hot-air gun temperature 100–480 °C, air-flow 0.5–23 L/min, earth resistance of bits < 2 Ω and drain voltage < 2 mV.
It is designed for surface-mount-device tasks including dis-/re-mounting QFP, PLCC, SOP, BGA etc. The hot-air feature and temperature control make it suitable for temperature-sensitive elements.
-
Anti-static design to avoid harming PCBs via static or leakage.
-
Intelligent cooling after use: after work is done it delays air supply and cuts off power once air temp <100 °C, to protect heating elements and extend life.
-
LED temperature display for accurate control and easier operation.
-
Install the correct nozzle only when the steel tube is cooled.
-
Keep a minimum distance (≈ 2 mm) between the hot-air outlet and the component.
-
Use lower temperature/higher airflow for smaller nozzles to avoid damage.
-
Use automatic cooling mode after operation before powering off. (The JAS-852D specification mentions this feature.)
-
The heating unit is a ceramic heating unit (A1321) in this model.
-
The airflow rate is adjustable from 0.5 to 23 L/min; this gives control over how much hot air is blown, allowing fine control to avoid damage to nearby components.
.jpg)
